going to try this stuff

Finally got time to sit down, read the documentation and start loading the software onto the SAM4S-XPRO using Atmel Studio 6.2.

Hooked up the board on using the Debug USB connector and it correctly loaded the EDBG drivers.
Atmel Studio 6.2 immediately discovered the SAM4S-XPRO so that was all sweet.

Exactly as per documentation, it required me to update the firmware and then I could set the clock speed:

So that's all good. But when I then go to the Hempstick SAM4S-XPRO Project Properties and Tools.... it only allows me to select 2Mhz at the most, rather than 12Mhz?

Is there something very obvious that I'm missing here?

Not sure why in the Project Tools it only allows you to select 2MHz. But that should be fine. The speed of SWD is not very critical. 2HMz should be fast enough.

This message was edited 3 times. Last update was at 24/01/2020 02:35:45

Hemepstead wrote:Not sure why in the Project Tools it only allows you to select 2MHz. But that should be fine. The speed of SWD is not very critical. 2HMz should be fast enough.

is it any good do you think?